{
    "Information": "資訊",
    "IDDQ:": "國際電話號碼：",
    "Module: ": "模組：",
    "sys-dock status:": "系統塢站狀態：",
    "SaltyNX status:": "SaltyNX 狀態：",
    "RR Display status:": "RR 顯示狀態：",
    "Wafer Position:": "晶圓位置：",
    "Credits": "製作人員",
    "Developers": "開發商",
    "Contributors": "貢獻者",
    "Testers": "測試人員",
    "Special Thanks": "特別感謝",
    "Unknown": "未知",
    "Installed": "已安裝",
    "Not Installed": "未安裝",
    "X: %u Y: %u": "X: %u Y: %u",
    "THE BEER-WARE LICENSE": "啤酒製品許可證",
    "Default": "預設",
    "Do Not Override": "不要覆蓋",
    "Disabled": "殘障人士",
    "Enabled": "啟用",
    " \\ue0e3 Reset": "\\ue0e3 重設",
    "Display": "顯示",
    "Application changed\\n\\n": "應用程式已更改\\n\\n",
    "The running application changed\\n\\n": "正在運行的應用程式已更改\\n\\n",
    "while editing was going on.": "當編輯正在進行時。",
    "Board": "董事會",
    "%u.%u%u mV": "%u.%u%u mV",
    "Could not connect to hoc-clk sysmodule.\\n\\n": "無法連接到 hoc-clk 系統模組。 \\n\\n",
    "Please make sure everything is\\n\\n": "請確保一切正常\\n\\n",
    "correctly installed and enabled.": "正確安裝並啟用。",
    "Fatal error": "致命錯誤",
    "Temporary Overrides ": "臨時覆蓋",
    "Sleep Mode": "睡眠模式",
    "Stock": "庫存",
    "Dev OC": "開發OC",
    "Boost Mode": "升壓模式",
    "Safe Max": "安全最大值",
    "Unsafe Max": "不安全最大值",
    "Absolute Max": "絕對最大值",
    "Handheld Safe Max": "手持式安全最大",
    "Enable": "啟用",
    "Edit App Profile": "編輯應用程式設定檔",
    "Edit Global Profile": "編輯全域設定檔",
    "Temporary Overrides": "臨時覆蓋",
    "Settings": "設定",
    "About": "關於",
    "Compiling with minimal features": "使用最少的功能進行編譯",
    "General Settings": "常規設定",
    "Governor Settings": "調速器設定",
    "Safety Settings": "安全設定",
    "Save KIP Settings": "儲存 KIP 設定",
    "RAM Settings": "記憶體設定",
    "CPU Settings": "中央處理器設定",
    "GPU Settings": "GPU設定",
    "Display Settings": "顯示設定",
    "Experimental": "實驗性的",
    "GPU Scheduling Override Method": "GPU調度覆蓋方法",
    "can be dangerous and may cause": "可能很危險並可能導致",
    "damage to your battery or charger!": "損壞電池或充電器！",
    "Charge Current Override": "充電電流覆蓋",
    "RAM Voltage Display Mode": "RAM電壓顯示模式",
    "Polling Interval": "輪詢間隔",
    "CPU Governor Minimum Frequency": "CPU調速器最低頻率",
    "refresh rates may cause stress": "刷新率可能會造成壓力",
    "or damage to your display! ": "或損壞您的顯示器！",
    "Proceed at your own risk!": "請自行承擔風險！",
    "Max Handheld Display": "最大手持顯示器",
    "Display Clock": "顯示時鐘",
    "Official Rating": "官方評級",
    "TDP Threshold": "TDP閾值",
    "Power": "電源",
    "Thermal Throttle Limit": "熱油門限制",
    "HP Mode": "惠普模式",
    "Default (Mariko)": "預設（真理子）",
    "Default (Erista)": "預設（埃里斯塔）",
    "Rating": "評級",
    "Safe Max (Mariko)": "安全最大（真理子）",
    "Safe Max (Erista)": "安全最大（埃里斯塔）",
    "RAM VDD2 Voltage": "RAM VDD2 電壓",
    "Voltage": "電壓",
    "RAM VDDQ Voltage": "RAM VDDQ 電壓",
    "RAM Frequency Editor": "RAM頻率編輯器",
    "JEDEC.": "JEDEC。",
    "High speedo needed!": "需要高速！",
    "3333MHz (Needs extreme Speedo/PLL)": "3333MHz（需要極高的 Speedo/PLL）",
    "3366MHz (Needs extreme Speedo/PLL)": "3366MHz（需要極高的 Speedo/PLL）",
    "3400MHz (Needs extreme Speedo/PLL)": "3400MHz（需要極高的 Speedo/PLL）",
    "3433MHz (Needs ridiculous Speedo/PLL)": "3433MHz（需要荒謬的 Speedo/PLL）",
    "3466MHz (Needs ridiculous Speedo/PLL)": "3466MHz（需要荒謬的 Speedo/PLL）",
    "3500MHz (Needs ridiculous Speedo/PLL)": "3500MHz（需要荒謬的 Speedo/PLL）",
    "Ram Max Clock": "記憶體最大時鐘",
    "RAM Latency Editor": "RAM 延遲編輯器",
    "RAM Timing Reductions": "RAM 時序減少",
    "Memory Timings": "記憶體時序",
    "Advanced": "進階",
    "t6 tRTW Fine Tune": "t6 tRTW 微調",
    "tRTW Fine Tune": "tRTW 微調",
    "t7 tWTR Fine Tune": "t7 tWTR 微調",
    "tWTR Fine Tune": "tWTR 微調",
    "Memory Latencies": "記憶體延遲",
    "Read Latency": "讀取延遲",
    "Write Latency": "寫入延遲",
    "CPU Boost Clock": "CPU 升壓時鐘",
    "CPU UV": "中央處理器紫外線",
    "CPU Unlock": "CPU解鎖",
    "CPU VMIN": "CPU最低電壓",
    "CPU Max Voltage": "CPU最大電壓",
    "CPU Max Clock": "CPU 最大時脈",
    "Extreme UV Table": "極端紫外線表",
    "CPU UV Table": "CPU UV表",
    "CPU Low UV": "CPU低紫外線",
    "CPU High UV": "CPU高紫外線",
    "CPU Low VMIN": "CPU 低 VMIN",
    "CPU High VMIN": "CPU 高 VMIN",
    "No Undervolt": "無欠壓",
    "SLT Table": "SLT表",
    "HiOPT Table": "HiOPT表",
    "GPU Undervolt Table": "GPU 欠壓表",
    "GPU Minimum Voltage": "GPU最低電壓",
    "Calculate GPU Vmin": "計算 GPU Vmin",
    "GPU VMIN": "GPU VMIN",
    "GPU Maximum Voltage": "GPU最大電壓",
    "GPU Voltage Offset": "GPU電壓偏移",
    "Do not override": "不要覆蓋",
    "Enabled (Default)": "啟用（預設）",
    "96.6% limit": "96.6%限制",
    "99.7% limit": "99.7%限制",
    "GPU Scheduling Override": "GPU 調度覆蓋",
    "Official Service": "官方服務",
    "GPU DVFS Mode": "GPU DVFS 模式",
    "GPU DVFS Offset": "GPU DVFS 偏移",
    "GPU Voltage Table": "GPU電壓表",
    "GPU Custom Table (mV)": "GPU 自訂表 (mV)",
    "1075MHz without UV, 1152MHz on SLT": "無 UV 時為 1075MHz，SLT 時為 1152MHz",
    "or 1228MHz on HiOPT can cause ": "或 HiOPT 上的 1228MHz 可能會導致",
    "permanent damage to your Switch!": "對您的 Switch 造成永久性損壞！",
    "921MHz without UV and 960MHz on": "無 UV 時為 921MHz，開啟時為 960MHz",
    "SLT or HiOPT can cause ": "SLT 或 HiOPT 可能會導致"
}